1420mm pipe bending machine

Specification:OD1420*100mm (Max bending diameter:OD1420mm,thickness:100mm)
                            Bending scope:OD660-OD1220mm, bending radius:3D-5D
OPERATION ON BENDING
1.Install of frequency coils
Install suitable frequency coil onto water pipe's transformer, then connect with water pipe and be sure no leakage there.
2.load materials of 1420mm pipe bending machine

Load material from the end of machinery, pipe (material) shall over than frequency coil ( subject to width of clips) .First adjust height of conveyor idler  and keep necessary level with pipe , then screw conveyor idler and make pipe in center of the hole. Transformer coils have equal distance around pipe (material),then turn back pushing board and screw pipe and ready to bend.
Please kindly contact with us for your interested Exported elbow maker,pipe bending machine,pipe expanding machine,hydraulic press, hot induction heating power.

Maintenance of machine:

The equipment should be maintained about once a month, maintenance as following:

1.Check each part of fasteners, ensure they are fixed.

2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.

3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.

4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.

5.When cleaning tank, you should clean the inside the oil filter of tank too.