Hei Yan Group offer beveling machine.

This machine adopts standard dynamic head to innovate the special dynamic cabinet, which has good cutting capacity and differential radial feeding. It has such funcitions as differential feeding, manual adjustment and eclectrical rapid feeding and retuining of knife; The clamping of working piece used clamping seat and chain soft clamping device on the working platform and the clamped piece will not be limited, thus, it can be used widely. The working piece can be spotted by regulation of main machine of dynamic cabinet from left side to right side and the reaulation of working platform from upper to lower; The pipe end cutting bevel adopts angle knife rest differential speed automatic feeding for processing.

Beveling machine for elbow pipe bender is a multifunction machine,It can support beveling work for elbow,tee,pipe,
Bender in the same machine,you need to change working table only for different products,for example:

Pipe Beveling: except the main working table,we need two brackets to support pipe also.
Elbow Beveling: we need a big working table to make elbow lay on it.
Bending beveling: Except the main working table,we need one extra bracket to support another bender end.

If you are interested in our beveling machine, don't hesitate to contact us. Hei Yan also supply elbow forming machine,pipe bending machine,pipe expanding machine,cold draw tee machine,hydraulic press,medium frequency power supply,moulds and so on.

Notes:
1 The bevel machine should place flat,stable fixation,to avoid moving when using.when the power supply connect well,
   please pay attention to check the operation direction and transmission parts.

2 Let the bevel machine clamp the pipe,prevent the collision of tools,the
   pipe end and the feedings should be left between the 2-3mm gap,to prevent
  excessive feed first time,turn on the malecoupling when working,to avoid the second feed at the same time.

3 After the feed,should remain in situ rotate a few times,so that smooth the bevel, move the knife frame after operation,
   which away  from the cutting surface,and then remove the pipe.

4 Cooling system must be kept clean to prevent the impurities,iron filings into the oilway,blocking the nozzle.

5 After finished the work,need do maintenance work