Fixed-type High Pipe End Beveling Machine

Performance features of Fixed-type High Speed Pipe End Beveling Machine:
          
On-line Performance: Good(Designed as per the one line equipment of the production line)
Beveling Capacity: ≤5Min /pipe bevel (DN200 SCH40)          
Bevel cutting: cutting a pipe with other equipment such as band saw and then machining each bevel.
Bevel quality: very good
Mobility: low
The Fixed-type High Speed Pipe End Beveling Machine is applicable to for machining the U or V shape bevels for numbers of pipes with thick wall
           
Technical parameters
Pipe diameter applicable: DN50~400(φ60~426); DN100~600(φ114~610); DN 200-800 ( φ219-813); DN 400-1200 ( φ 426-1219)
Pipe wall thickness applicable: 6~90MM ; 6~180MM
Materials applicable: carbon steel, alloy steel, stainless steel ect.
Bevel shape: compound bevel, V, X, U & Double V etc
Cutting direction: lengthwise
Driven by: motor
Clamping system: work piece is clamped by hydraulic cylinder/manual screw clamping; manual screw clamping
Bracket system: screw lifting and lowering manually
            
Automatic aligning: An end beveling machine conveying system equipped with   lifting and lowering device could be provided if necessary to adjust automatically the center elevation of the pipe, so as to bevel the pipes with different diameters.

Hei Yan Group is  a high and new-technology enterprise specialized in the design, development and manufacture of elbow machine,bending machine,pipe end facing and Fixed-type High Pipe End Beveling Machine,pipe expanding machine and tee machine

Notes:
1 The bevel machine should place flat,stable fixation,to avoid moving when using.when the power supply connect well,
   please pay attention to check the operation direction and transmission parts.

2 Let the bevel machine clamp the pipe,prevent the collision of tools,the
   pipe end and the feedings should be left between the 2-3mm gap,to prevent
  excessive feed first time,turn on the malecoupling when working,to avoid the second feed at the same time.

3 After the feed,should remain in situ rotate a few times,so that smooth the bevel, move the knife frame after operation,
   which away  from the cutting surface,and then remove the pipe.

4 Cooling system must be kept clean to prevent the impurities,iron filings into the oilway,blocking the nozzle.

5 After finished the work,need do maintenance work