Bends machine

The head position and the bed part of the bends machine is made of solid material. And after annealing it can eliminate internal stress. In total, there is enough strength and rigidity to prevent permanent deformation. When transmit principal axis, it can insert into the head part directly with accurate installation and convenient maintance. The principle axis of the bending pipe and the chain of the transmittion forged as a whole, and with overall process and  overall hobbing. Without key link, it is of better power distribution. Driven by a double-cylinder , when the arm is near the settleed point of bending,the hydraulic system will buffer automatically, improving the precision of reset and the work efficiency.Full hydraulic drive, micro-controller can be preset of 16 angle,the use of foot switch will complete the whole process.

Size of bends machine: OD219-OD1420

Accesory of bends machine:electric heating power source 

Maintenance of machine:

The equipment should be serviced about once a month, maintenance as following:

1.Check each part of fasteners, ensure they are fixed.

2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.

3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.

4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.

5.When cleaning tank, you should clean the inside the oil filter of tank also