Carbon steel elbow forming machine

Hei yan Int'L Development Limited would like to introduce our machine to you:

Raw material of producing elbows: seamless steel pipe, welded steel pipe and rolled steel pipe. 

The range of the elbow that our Carbon steel elbow forming machine can produce is as following: OD: 1 inch (25mm)- 60 inches (1420mm); 

Thickness: 5mm - 120mm; 

angle: 22.5 degree 45 degree 90 degree 135 degree and the angle of user needs. 

Based on thermal expansion elbow diameter, wall thickness, EWT-1 Hydraulic elbow to push the system is divided into 10 series specifications. Specifications and technical parameters of our Carbon steel elbow forming machine,please check the following part machine specification.

Maintenance of machine:

The equipment should be serviced about once a month, maintenance as following:

1.Check each part of fasteners, ensure they are fixed.

2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.

3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.

4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.

5.When cleaning tank, you should clean the inside the oil filter of tank also.