Elbow Forming Machine

Components of elbow forming machine
   support rod
   brackets
   clamp device
   proximity switch
   automatic welding head
    lift platform,
    rail

Design of elbow forming machine there are two support rods,which were placed in the two brackets,the distance between the two brackets can be adjusted to suit the butt welding elbows in various diameters.

    the lifting platform placed in horizontal rails and can slipe on it. the upper parts of lift platform are equipped with clamp devices,
   
    the machine head placed on the top of lift platform,and can slide above.The top surface of machine head installed proximity
   switch that used for adjusting the tilt angle.

Advantages of elbow forming machine 
   simple in structure
   high productivity
   suitable for non-horizontal seam welding and welding of thin-thickness.
  

Maintenance of machine
 The equipment should be serviced about once a month,maitenance as follows:

1 Check each part of fasteners,ensure they are fixed.

2 Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings.
 If the seal rings appear damaged or oil leakage,should be replace timely.

3 If found forward or backward operating abnormality,fist check electro-hydraulic valve whether
  Operate normal,if working normally,then you should check whether the electro-hydraulic relief
  Valve or the one-way unloading valve has contaminant or not, made it could not work
( this phenomenon usually happen when you just use this machine) if has contaminant, you should
Open it, clean by gasoline or diesl oil,everything is ok, then re-install.

4 Operated this equipment within 15days,you should clean the tank and filter hydralic oil once

5 When cleaning tank,you should clean the inside the oil-input of tank also.