|
|
| Stainless steel elbow forming machine |
|
| Type:HTW-2 series cold forming |
| Specification:OD21mm-610mm |
| Application:Inductry,construction,shipbuilding |
| Delivery:30-60days |
 |
|
|
|
| |
Your Demand,Our Liability TEL:0086-13931764957 E-mail:ceo@xnmac.com |
|
|
|
|
Stainless steel elbow forming machine
The Stainless steel elbow forming machines are designed and constructed not only for manufacturing the small radius (1.0D-1.5D) standard stainless steel elbow, but also for the carbon steel elbow.
Specification:
1. Production range: OD21mm-610mm
2. Radius: 1D, 1.5D
3. Thickness: 3mm-18mm
4. Drive type: Hydraulic
Forming principle: Tube in the tunnel locked by the external cavity, the hydraulic plunger was pushed from the guide section to the forming section that set with inner core ,and demould by the demoulding equipment , the whole adopt PLC intelligent operation.
More information of our Stainless steel elbow forming machine ,please contact with us. |
| |
| Your Demand,Our Liability TEL:0086-13931764957 E-mail:ceo@xnmac.com |
|
|
|
|
Cold elbow forming machine processing scope and mould equipment |
|
Type |
Processing scope(inch) |
Mould |
Forming speed |
|
63T |
1/2-2 |
OD32,38,45,57 OD34,42,48,60 |
15-20s/pc |
|
100T |
21/2-5 |
OD76,89,102,108,114 |
20-30s/pc |
|
400T |
5-8 |
OD133,140,159,168,219 |
40-50s/pc |
|
630T |
6-12 |
OD159,168,219,273,325 |
120-160s/pc |
|
800T |
10-16 |
OD273,325,377,426 |
250-300s/pc |
|
1000T |
12-20 |
OD325,377,426,503 |
350-450s/pc | |
|
|
|
Maintenance of machine:
The equipment should be serviced about once a month, maintenance as following:
1.Check each part of fasteners, ensure they are fixed.
2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.
3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.
4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.
5.When cleaning tank, you should clean the inside the oil filter of tank also.
E-mail:ceo@xnmac.com
Fax:0086-317-3017257
Website:www.xnmac.com
www.elbow-machine.com |
|
|
|
|
|
| Your Demand,Our Liability TEL:0086-13931764957 E-mail:ceo@xnmac.com |
|
 |
Related Products |
|
|
|
|
|
