Working principle with sawing machine.
Hydraulic transmission system is composed of pump, valve, oil cylinder, fuel tank, pipeline and other components of the hydraulic circuit, under electric control to complete the lifting of the saw beam, the workpiece clamping.The speed regulating valve can be used to speed stepless speed regulation to meet the needs of different materials.Electrical control system controlled by the electrical box, box, junction box, travel switch control circuit, electromagnet, etc, used to control the saw blade, saw slewing beam lifting, workpiece clamping and so on, make it according to certain procedures to implement the normal cutting cycle.
Lubrication system must be according to the machine tool lubrication part before driving (wire brush shaft, worm worm gear box, the active bearing, bearing, lift up and down cylinder shaft clamping screw sliding surfaces, vise for refueling.Worm gear box of worm gear, worm with 30 oil oil bath lubrication and oil plug hole injection by the upper part of the worm gear box, box fairy side has oil mark, when saw beam in the lowest position, the oil level should be between the upper and lower oil mark.After a month's trial, oil should be changed. Once every 3-6 months, the oil will be changed once every 3 to 6 months.Saw blade installed on the worm gear box drive motor through the pulley, triangle tape drive worm gear box of worm and worm gear, drives the driving wheel rotation, to drive around the active, passive wheel rim on the saw blade for cutting rotary motion.
Powered By 2015 @ HEIYAN Group. All Rights Reserved