Intermediate frequency heating pipe bending machine

The intermediate frequency heating pipe bending machine use seamless steel pipe,welded pipe,roll pipe as raw materials.
Technical Parameter of intermediate frequency heating pipe bending machine

1.Bending pipe's outer diameter:  OD219mm,325mm,426mm
2.The maximum thickness:    18mm,25mm,40mm
3.Angle of bend: 180degree,180degree,180degree
4.Relative bend radius: 3D~6D,3D~6D,3D~6D
5.The maximum stroke of main cylinder: 2.5m  3.5m  4.5m
6.The working pressure of hydraulic pressure system:10Mpa  10Mpa  10Mpa

Hei Yan international supply elbow machine,pipe expanding machine, pipe bending

machine,hydraulic press,bevel machine also.

The equipment should be serviced about once a month, maintenance as following:

1.Check each part of fasteners, ensure they are fixed.

2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.

3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.

4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.

5.When cleaning tank, you should clean the inside the oil filter of tank also.