500T Cold elbow machine in China Technical data of 500T Cold elbow machine in China: Mould clamping force:500 T Pushing force:250 T Moter power:18.5KW*2 Working table: 1600mm*1000mm
The main machine consists: Main body(frame), Closing cylinder, Side pushing cylinder, Demoulding equipment . Control equipment is made up of power station, stop block, pipe line and equipment control box, operation box etc.
Forming principle of 500T Cold elbow machine in China: Tube in the tunnel locked by the external cavity, the hydraulic plunger was pushed from the guide section to the forming section that set with inner core ,and demould by the demoulding equipment , the whole adopt PLC intelligent operation. Hei yan also manufacture hot elbow forming machine,Pipe bending machine,Pipe expanding machine and heating power.
Your Demand,Our Liability TEL:0086-13931764957 E-mail:ceo@xnmac.com
1. Before starting, check parts of press manipulation, clutch and brakes are active, the security guard is complete and easy to use, whether ministries crank exception. If abnormal, should immediately take the necessary measures 2. Before formal operating subject to idle test, be sure each part can normal work. 3. The operation must use the tools, is prohibited by hand directly into his mouth extract die, hand tool should not be putted on the mold. 4. Foot must be far away from the foot pedals, when adjust or get the workpiece in mould area. 5. Sudden power off or operate finished, we should close the power, and restored to the clutch in neutral gear manipulator, brake in braking. 6. On the press for maintenance, adjustment and installation, adjustment, dismantling the mold should be disconnected the machine energy (such as electricity, gas, liquid). Putting warning notice on the startup switches.
