Induction based elbow pushing machine

Structure and Working Principle of HY type Induction based elbow pushing machineThis equipment adopts double cylidner working method,together with intergrated pump station.
The pump station consists of multi stage pump:specifics from one to six adopts 2~3 pump station,the remaining adopt one fast speed pump station.

Induction based machine is used in various industries for manufacturing fasteners, carbide cutters, hardware tools, stainless steel products, automobile/motorcycle parts, hot forming of pipes & tubes and stone work.
Some of the properties of that make it a favorite with the clients are:Pipe fitting industry, petroleum industry, oil gas industry,boiler industry,construcion,infrastructure etc

Usage of Induction based elbow pushing machine

First,induction heating power source will be put in the front part of machine,induction coil will be put on the adjustable shelf.Second,after the preparation of mandrel and pipe,tur on the water pump and induction heating power source,adjusting frequency,thus heating the mandrel and pipe.Third,turn on the pushing machine and expand pipe.Silicon thyristor,induction coil,capacitor,reactor circulate to cooling water.
The electric control part will be installed in the electric box.Two sides of the equipment will be equipped with switch,when reach the standard,it will automatically stop.

Hei Yan Group ,invite clients to visit induction based elbow pushing machine factory and visit hydrualic pipe bending machine,ERW pipe,elbow,reducer etc.

Note:The actual stroke should be less than the Max stroke,which means it will be 30~50mm space left for front and rear,to avoid the cylinder strike the cylidner flange,result damage to the equipment.
The equipment should be installed according to the foundation drawing the manufacturer offered,the equipment shoud be placed flat.Before shipment, the eqipment will be tested to fine condition.After water and electricity Ok,manufacturer will install and debug.

Requirement of the workshop
1Pump station and induction heating power source had better be placed in the sub room of the workshop
2The cooling water pond should be bigger than 50 cubic meters and equipped with anti-dust measures.
3 The length of workshop had better longer than 45-60meters,wideth should be 8-12 meters.